Menu
Instructions for mounting and using a mast with an external cord system
Mounting
- The flagpole is pre-installed lynx house ja
flagpole. - Insert the cord protruding from the top of the flagpole (end of
to the lower end of the mast attached for transport)
sleeves through the inside so that the end of the cord protrudes from one of the sleeves cord
from the exit groove. - Put the end of the string through the small one plastic wind, its
by a smaller opening and then fasten the metal
carabiner to the string. Done knot remains in the plastic wind
nest. - Move the sleeve to the top of the mast and push the sleeve onto the mast so that
to fix it. - Put the flag counterweight (either chain or ring weight)
mast and attach it to the metal carabiner of the flagpole. - Turn around top ball to the sleeve.
- Push the flag upright and adjust with the adjusting nuts
created; tighten the nuts. Do not raise the flagpole
without counterweight. - Check and, if necessary, tighten the anchor nuts 2 - 3
weeks after the mast is installed and each time the flag
you switch.




Raising the flag
- Unscrew the lock house with the key and remove the lock house
cover. - After pushing the mast up, there is an end of the flag rope and a counterweight
at the lower end of the mast. Release the counterweight weight
from the carabiner and attach the bottom eye of the flag
the weight of the counterweight and the uppermost loop to the carabiner. - If you have a large flag that needs to be affixed with plastic rods, then
put the rods around the mast and pass the flag through the remaining loops;
close the plastic rods by connecting their ends. - Release the flag rope from the mounting groove and raise the flag,
by pulling the flag line, about 45 ̊, in the direction top to bottom (cord
exits the upper and enters the lower opening in the house of the castle) -
it may require more force. - When the flag has reached the top of the mast and the flag rope is tight,
pull the cord into its mounting groove so that it locks in place.
Push the excess cord into the lower opening of the lynx house and
close the castle house with its lid. Unscrew the lid and
remove the key.

Lowering the flag
- Unscrew the lock house with the key and remove the lock house
cover. - Release the cord from its attachment groove, holding the cord for approx
At a 45 ̊ angle, allow the cord to move inside the mast,
direction from bottom to top (leaves the lower and enters the upper
cord opening). - When the flag has moved to the appropriate height, pull the cord
the mounting grooves so that it locks in place. - If you used plastic wicks, remove them.
- Release the flag from the rope and the counterweight.
- If you want to install a new flag, follow the steps
instructions in the "hoisting the flag" section. If you don't
If you want to fly the flag at the moment, connect the string and
counterweight carbines. - Release the flag rope from the mounting groove and pull the counterweight
up by pulling the flag line from top to bottom. - When the counterweight has reached the top of the mast and the flag line is tight,
then pull the cord into its groove so that it locks in place.
Push the excess cord into the lower opening of the lynx house and
close the castle house with its lid. Unscrew the lid and
remove the key.
